Everything comes together for a 1st prototype

This week my 1st self designed PCBs arrived from eurocircuits.com.

Below you see the frontside view, which is holding basically all components, more to that later.
PCB front

This is the PCB backside where actually only the 2X13 PIN connector goes in.
PCB backside

I used some one-way plastic soup bowls to assort the components for the three prototypes.
Assorted components

In the step below all resistors and the two ICs (MCP 3008 and MCP 23S17) have been soldered to the board.
ICs added

Almost there, connector for PIR and IR proximity added, DHT22 (Temperature & Humidity Sensor) and 7-segment displays added.
DHT22 and connector for IR proximity added

Completely assembled it looks like this.
Fully loaded shield prototype

To put it on the RaspberryPi I needed some extra tall stacking headers.
Stacking header für Raspberry Pi (extra tall)

Finally, this is how the shield looks when it is added to the Raspberry Pi.Prototype Shield on Raspberry Pi