This week my 1st self designed PCBs arrived from eurocircuits.com.
Below you see the frontside view, which is holding basically all components, more to that later.
This is the PCB backside where actually only the 2X13 PIN connector goes in.
I used some one-way plastic soup bowls to assort the components for the three prototypes.
In the step below all resistors and the two ICs (MCP 3008 and MCP 23S17) have been soldered to the board.
Almost there, connector for PIR and IR proximity added, DHT22 (Temperature & Humidity Sensor) and 7-segment displays added.
Completely assembled it looks like this.
To put it on the RaspberryPi I needed some extra tall stacking headers.